Historically, you would console into the One100 and type CLI commands all day. With (Telecom Operating Platform or Topology Manager), you don't.
: Should be solid green. A blinking or amber LED usually indicates a boot failure or a factory-default state requiring onboarding.
If auto-provisioning fails:
Once logged in, enter privileged EXEC mode to start configuration:
Once logged into the OneAccess CLI shell, use the following sequence to build a basic routing and internet access configuration. 1. Entering Privileged and Configuration Modes Router> enable Router# configure terminal Router(config)# Use code with caution. 2. Configuring the LAN Interface oneaccess one100 installation manual oneaccess top
Here are solutions to typical problems you may encounter.
[ Internet / Service Provider ] │ ▼ ┌──────────────┐ │ WAN Port │ │ │ [ Administration PC ] ──►│ Console Port │ ONE100 ROUTER │ │ │ LAN Ports │ └──────┬───────┘ │ ▼ [ Local Network Switch / PCs ] Historically, you would console into the One100 and
Always change the default passwords during first login. Use the command: # passwd admin