Xycd60 Manual

The relay closes and starts discharging (powering your load) when the battery voltage is at or above the Upper Limit (UP) Deactivation:

Short/long press to increase values, switch modes (Charging/Discharging).

Use this mode to connect a charger to a battery, cutting off power when the battery is full. Connect battery to input, charger to output.

Long press DOWN to turn on/off the display backlight to save energy. ON : Screen turns off after 5-10 minutes. xycd60 manual

Ensure the load connected to the output does not exceed the relay's rated capacity (typically 10A–30A depending on the specific sub-model variant).

OFF : Screen stays on constantly [as per Scribd User Manual]. 7. Typical Application Examples

Disclaimer: This manual is a reconstruction based on standard operating procedures for the XYCD series of temperature controllers. The manufacturer may update firmware or hardware without notice. Consult the specific paper insert included with your product for exact terminal diagrams. The relay closes and starts discharging (powering your

The device automatically cuts off charging when the battery reaches its full voltage (overcharge protection) and disconnects the load when the battery’s voltage drops too low (over‑discharge protection). Typical applications include solar storage systems, lead‑acid and lithium‑ion batteries for RVs and boats, off‑grid power systems, automotive and marine batteries, DIY electronics projects, and industrial control panels.

Here are the most frequently reported issues and their solutions.

Navigating your module is straightforward through the LCD screen and the control buttons. Long press DOWN to turn on/off the display

Adds a delay (in seconds) between reaching the activation voltage and the relay actually closing.

Given the ambiguity of the model number, here is a final guide to help you find the correct information: