Xta-7000 Temperature Controller Manual (500+ LEGIT)
Press the key again to save your new target temperature. Running Auto-Tuning (AT)
Solution: Inspect sensor wiring connections. Test the continuity of the thermocouple or RTD element with a multimeter. Replace the sensor if it is open-circuited.
right now I only provided power supply to this controller. so let's check first that display is getting on or not turn on the MCB. YouTube·The Electrical Guy XMTG-7000 Programmable Temperature/Time PID Controller
The actual temperature measured by your sensor (displayed in red). SV (Setting Value):
Supports various Thermocouples (K, E, S, J) and RTDs (Pt100, Cu50). xta-7000 temperature controller manual
Used to increase/decrease values or cycle through menu options.
Used to increment or decrement the numerical values on the SV display. 4. Programming the Controller: Step-by-Step Configuring the
To access hidden system protection profiles and advanced optimization configurations, hold down the specialized or the combined SET command loop for approximately 3 seconds. Proportional-Integral-Derivative (PID) Parameter Reference
Activating launches an automated system evaluation curve to calculate P, I, and D parameters tailored to your enclosure. Accessing the Hidden Protection Lock Press the key again to save your new target temperature
Indicates the Set Value (target temperature) or parameter values during programming.
When the PV row populates the initialization parameter code, check the SV string. Press or Down (
Indicators marked OUT (control output active) and ALM1 / ALM2 (alarm threshold trip status) offer real-time debugging insight.
Proper wiring is critical to avoid electrical noise interference and protect internal circuitry. Always disconnect the main power supply before making any wiring connections. Panel Mounting Prepare a standard panel cutout measuring 68mm x 68mm. Replace the sensor if it is open-circuited
Standard 0–10mA or 4–20mA configurations.
Used to initiate auto-tuning or return to the main menu. Shift Button ( <
Press and hold the key for 3 seconds to enter the primary parameter menu. Press SET repeatedly until the SV display reads AT .