Videojet 1280 Manual Pdf Install Jun 2026

With configuration complete, it is time to test the ink stream.

Press the physical button or tap Start Jet on the touchscreen interface.

Connect your product sensor (photocell) and shaft encoder to the designated ports on the back of the printer to ensure accurate print timing.

Before unboxing, ensure your production site meets these environmental and electrical standards: videojet 1280 manual pdf install

Once the hardware installation is complete, follow this sequence to initialize the operating system.

Electrical installation must be performed by a qualified electrician.

Use a spirit level to ensure the cabinet sits perfectly horizontal. 3. Printhead and Sensor Installation With configuration complete, it is time to test

Pro Tip: You are looking for two specific documents: The (for electrical/air requirements) and the Operator Manual (for physical setup).

Secure the printer base to the official Videojet stand using the provided bolts.

: Ensure the umbilical (the cable connecting the cabinet to the printhead) has no sharp bends or kinks. The minimum bend radius is typically 150mm (6 inches). Fluid Setup Before unboxing, ensure your production site meets these

: Position the printhead on its bracket. The printhead should ideally be at the same level as, or lower than, the printer cabinet.

: For advanced job delivery via CLARiSOFT Package Coding Design software or remote monitoring, plug a standard network cable into the integrated Ethernet or optional RS232 serial module ports. Step 3: Fluid System Priming and Cartridge Installation Videojet 1240_1280 Operator Manual.book - Bid on Equipment

The "Videojet 1280 manual pdf install" is the most comprehensive resource for the setup process. However, Videojet does not always provide a direct, public-facing PDF download link. Instead, they provide support through official channels to ensure you receive the most up-to-date version.

The 1280 is engineered for minimal upkeep, keeping your line running with little intervention.

Keep the distance between the printhead face and your product substrate within to prevent characters from spraying unevenly. 🔌 Step 2: Electrical and I/O Sensor Connections