Staples 17466 Laminator Manual New!

Place your document inside a laminating pouch that is slightly larger than the item itself. Center the document, leaving a border of at least 3 millimeters on all sides. The factory-sealed edge of the pouch (the closed side) should be the leading edge that goes into the machine first.

Let the machine sit for another 2 minutes until the green light stays solid. Run the document through a second time to melt the remaining adhesive. Pouch is Wavy, Warped, or Bubbling

This comprehensive guide serves as your complete owner's manual, covering technical specifications, setup procedures, operating steps, and troubleshooting techniques. Technical Specifications staples 17466 laminator manual

Ensure there is at least 6 inches of clear space behind the machine for documents to exit freely. Plug the power cord into a standard 120V AC outlet.

Do not leave the laminator unattended while it is turned on. Keep the laminator away from water and damp environments. Place your document inside a laminating pouch that

: Users must place their document inside the pouch, ensuring it is centered with at least an 1/8-inch border on all sides for a complete seal. Feeding the Machine : The pouch should always be inserted sealed-edge first

If your laminator is not performing correctly, follow these troubleshooting steps. What to Do If the Laminator Jams If a pouch jams, do not pull it forcefully. Let the machine sit for another 2 minutes

Always laminate the full pouch first, then trim the edges afterward. Cutting the pouch beforehand causes glue to leak onto the internal rollers.

Disclaimer: This guide is based on general operating procedures for Staples brand 9-inch laminators. Always refer to the physical instruction manual included with your specific product for the most accurate information.