LIFE PROBO PR70: FULL INSTALLATION, USE, AND MAINTENANCE MANUAL
: The guide includes critical procedures for manual release in case of power failure, requiring the installer to permanently fix a descriptive label near the release key.
: In case of power failure, pull the release cord (often orange) to disengage the drive carriage and move the door by hand. 3. Maintenance & Safety Reduced Maintenance
Maintain at least 40mm of vertical clearance between the top of the garage door and the ceiling.
Hereby, declares that the radio equipment type PROBO PR70 / PR70-DL is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.lifehomeintegration.com/doc/probo-pr70 LIFE PROBO PR70: FULL INSTALLATION, USE, AND MAINTENANCE
Thank you for purchasing the Life Probo PR70. This 10-page manual provides comprehensive instructions for installation, daily use, and long-term maintenance. Failure to follow these guidelines may void the warranty.
Raise the motor head and use the hanging straps to secure it to the ceiling.
documentation. Always consult the specific, original instruction manual that came with your product for exact technical details and updated safety information. PROBO - montaza.lv
: Obstacle detection sensitivity can be adjusted by holding the red button for five seconds and using the plus/minus keys to select a level. Electrical Connection Maintenance & Safety Reduced Maintenance Maintain at least
Installation must be performed by qualified personnel in compliance with local regulations.
: Only professional fitters should perform the installation. 2. Installation Steps
The PR70 has a self-diagnostic system, but physical checks are required.
Connect the straight arm component to the mechanical chain trolley. The automation will automatically close
Before installing, using, or performing maintenance on this unit, please read this manual thoroughly. Retain it for future reference.
: Operates on a 230V AC mains supply with a 24V DC motor.
: Press the "step command" key on your remote. The automation will automatically close, open, and close again to find the mechanical stops. Confirmation