Look at the console output window at the bottom. Find the file path ending in .hex . Copy this file path string. Running the Simulation
The JHD-2X16-I2C is a 16x2 character LCD module integrated with an I2C serial interface (usually based on the expander chip). Simulating this in Proteus requires specific addressing and libraries to bridge the I2C protocol with the standard LCD controller. 🛠️ Simulation Setup in Proteus
(or your preferred microcontroller, such as a PIC or 8051) JHD2X16I2C (or the PCF8574 + LM016L subsystem) Two Pull-Up Resistors (10kΩ) Wiring Guide Connect the hardware nodes as follows: jhd2x16i2c proteus free
This is exactly how the popular LiquidCrystal_I2C library works. Simulating this in Proteus allows you to see the waveform on the I2C Debugger.
Generally 0x27 or 0x3F , depending on the hardware revision and address pin configuration. Setting Up Proteus for JHD2X16I2C Simulation Look at the console output window at the bottom
: A system that uses the LCD to show current illumination levels and settings, with three buttons for user interaction (“+”, “-”, and “OK”).
Show you how to using the hardware jumpers in simulation? Running the Simulation The JHD-2X16-I2C is a 16x2
Which are you pairing with the display? (Arduino, PIC, STM32?)