Everstart Battery Charger 60108m Manual [repack] Jun 2026

The EverStart 60108M is a versatile tool designed for 12-volt battery systems. It features a straightforward control panel with three primary operational modes:

A slow, gentle trickle charge. This setting is ideal for small batteries (like those in motorcycles, lawnmowers, or ATVs) or for maintaining a full charge on a stored vehicle.

: Never operate the charger in a completely closed area. Ensure adequate airflow around the battery.

: Standard (Flooded/Wet Cell), AGM (Absorbent Glass Mat), and Gelatin (GEL) batteries Engine Assist : 28A temporary start aid function everstart battery charger 60108m manual

Working with lead-acid batteries carries inherent risks of explosion, electric shock, and chemical burns. Always follow these safety protocols before operating the charger:

Connect the charger clamp to the free end of the jumper extension cable, standing as far away from the battery as possible.

Set the toggle switch to your desired mode ( for maintenance, 15A for standard charging, or 100A for engine starting). The EverStart 60108M is a versatile tool designed

If it is excessively hot, smells like burning plastic, or vibrates loudly, you may be drawing too many amps for too long (e.g., leaving it in Engine Start mode). Unplug it immediately and allow it to cool down. Maintenance and Storage

The 60108M features switches to select the correct voltage and current output for your specific task:

Choose the correct voltage () to match your battery . : Never operate the charger in a completely closed area

: 2 Amp (trickle/maintenance), 10 Amp (rapid), and 25 Amp (maximum rapid charge). Battery Compatibility : Works with 12-volt Standard, AGM, and Gel batteries. Advanced Modes : Includes a Battery Reconditioning mode to help reduce sulfation and a mode for starting vehicles with low batteries. Safety Features

The unit includes an internal fan to manage heat during high-amperage charging; ensure the vents on the back are not obstructed. troubleshooting steps for a particular error code on the display?