Disco 240 Dmx Controller Manual (Official)

Once your show is programmed, the Disco 240 offers three distinct playback methods to suit different event styles. Manual Mode

A scene is a snapshot of a specific lighting look. Follow these steps to build and save a scene:

is a popular, cost-effective, and versatile option for DJs, bands, and venue owners.

The Disco 240 DMX controller is a staple console for mobile DJs, small clubs, and stage lighting technicians. It offers 240 channels of DMX control, allowing you to manage up to 12 intelligent lighting fixtures with up to 20 channels each. disco 240 dmx controller manual

For users just wanting to run pre-programmed "Auto" or "Sound Active" modes, the manual does an adequate job.

The Disco 240 DMX Controller is a workhorse for small to medium-sized events. While its 16-channel fixed addressing may seem limiting compared to modern PC-based software, its physical faders and straightforward programming make it incredibly reliable for live performance. By following this guide, you should be able to cable your system, assign your DMX addresses, and program a dynamic light show in just a few minutes.

Adjust the to change step transition smoothness. Once your show is programmed, the Disco 240

Repeat these steps to build up to 8 unique scenes within that bank. 6. Creating Chases and Automated Shows

A chase is a dynamic sequence made by linking multiple programmed scenes together. You must program your static scenes before compiling a chase.

Use the SCANNER buttons (P1-P12) to select which light(s) you want to control. The Disco 240 DMX controller is a staple

The controller utilizes an internal microphone or audio line input to trigger chase steps to the beat of the music bass line.

Verify that your lighting fixture's DMX start address matches the layout table in Section 2. Ensure your DMX cables are firmly chained from the board's "DMX Out" port to the "DMX In" port of the first light.

Press and hold the button for three seconds until the display flashes. Press a Scanner button to select your target fixture. Adjust the faders to design your desired look. Press the MIDI/Rec (or Program/Record ) button.