: Place the bike on a level surface with a protective mat. Maintain at least 2 feet (0.6 meters) of clearance around the unit.

that explains this, check Section 4: “Crank and Belt System” – subsection 4.3 “Collar Adjustment & Thread Protection.”

Tighten the pedals securely into the crank arms using your assembly wrench. Uneven floor placement

When active, the display will automatically cycle through all metrics every few seconds. Pulse Sensors:

I can provide target instructions based on your exact situation. Share public link

To prolong the lifespan of your exercise bike, perform regular checks to prevent premature wear and tear.

Secure it using two carriage bolts, curved washers, and cap nuts. Tighten firmly with the multi-wrench.

Lightly lubricate the seat post and handlebar post tubes with a silicone-based spray to keep them sliding smoothly.

: Slide the seat post into the frame. Secure it with the adjustment knob. To adjust, turn the knob several times to loosen, pull it out to slide the post, then release and tighten back into position. 3. Console & Workout Operation

Lot # 3922: DP Bionix Prime Fit Exercise Bike Station ... - 1BID

Once assembled, your Bionix Prime Fit Exercise Bike is ready to use. Please follow the steps below:

Thread the counter-clockwise into the left crank arm.Tighten both pedals firmly with the included wrench to prevent unthreading during use. Step 5: Connecting the Console

Ensure the pulse cables are fully plugged into the rear ports of the console. Loose pedals

Time, Speed, Distance, Calories, Odometer, and Pulse Heart Rate Monitoring: Integrated handlebar pulse sensors