Asprogrammer+21013 | Full & Secure

If you are using a CH341A programmer, you must install the specific parallel driver rather than the serial (COM port) driver. Locate the CH341PAR.EXE setup file within the extracted Drivers folder, right-click, and choose Run as Administrator to complete installation.

Open Device Manager. Under "LPT and COM ports," you should see "CH341A" or "USB-SERIAL CH341A."

is a popular open-source software used for programming EEPROM and Flash memory chips, most commonly paired with the CH341A USB programmer . It is widely used by technicians to repair or update BIOS on motherboards, routers, and other electronics. Quick Setup Guide asprogrammer+21013

AsProgrammer dregmod allow you to program flash ... - GitHub

: Always ensure you have the correct CH341A drivers installed before running the software. If you are using a CH341A programmer, you

is a highly optimized, open-source graphical user interface (GUI) software tailored for flashing non-volatile memory via the incredibly popular and budget-friendly CH341A USB hardware programmer . In the hardware repair and modding community, this specific version ( 2.1.0.13_fix ) stands out because it solves the stability glitches, memory leaks, and incomplete chip definitions that plagued older, proprietary Chinese software releases like CH341A Programmer v1.34. Whether you are recovering a bricked motherboard BIOS, dumping graphics card VBIOS firmware, or reprogramming routers, AsProgrammer 2.1.0.13 provides a safe, precise hex-editing environment to interface with SPI, I2C, and MicroWire EEPROM and Flash chips. Core Hardware & Software Compatibility

[Unprotect Chip] ➔ [Erase Chip] ➔ [Blank Check] ➔ [Open File & Write] ➔ [Verify Data] Under "LPT and COM ports," you should see

The toolbar is your primary control panel for the following key functions:

Before changing any data, click . Once the hex editor view fills with your current firmware data, go to File ➔ Save As and back it up as a raw .bin file. Step 4: Erase the Chip