Acer N20c5 Storage Driver Guide

– Not "N20C5". Use your actual laptop model, e.g., "Aspire A515-56" or "TravelMate P2 TMP215-53". Pro tip: The N20C5 driver is listed under Chipset or Storage category.

and select the folder on your USB where you extracted the driver. Select the Intel RST VMD Controller (e.g., model 9A08 or 9A0B) from the list.

: Intel Rapid Storage Technology (IRST) Driver.

Because your laptop cannot boot into an operating system yet, you must load this driver using a secondary USB flash drive (or extract it directly onto your Windows Installation USB). Step 1: Extract the Driver Files acer n20c5 storage driver

Disable VMD in BIOS temporarily. Reboot → Press F2 during boot → Go to Advanced → VMD Configuration → Set Enable VMD to Disabled . Save and exit. Note: After disabling VMD, Windows will use the standard NVMe driver. Performance may slightly drop, but compatibility improves.

Click . The driver will load, and your NVMe SSD should now appear in the list. Select the drive and proceed with the installation. 6. Alternative Method: Disabling VMD in BIOS

This is the most critical use case—when Windows Setup cannot see the NVMe drive. – Not "N20C5"

For the Acer N20C5 (TravelMate P2 series), the storage controller is almost always Intel-based.

The Windows installation environment cannot read raw .zip files. You must extract the components first.

Ensure you downloaded the VMD driver matching your processor generation. An 11th Gen driver will often fail to initialize on a 12th Gen motherboard architecture. and select the folder on your USB where

Are you doing a clean installation, or is the drive not loading in Windows? Do you see "VMD" in your BIOS settings?

: Allows the Windows installer to communicate with the NVMe SSD through the Intel VMD controller.

– Not "N20C5". Use your actual laptop model, e.g., "Aspire A515-56" or "TravelMate P2 TMP215-53". Pro tip: The N20C5 driver is listed under Chipset or Storage category.

and select the folder on your USB where you extracted the driver. Select the Intel RST VMD Controller (e.g., model 9A08 or 9A0B) from the list.

: Intel Rapid Storage Technology (IRST) Driver.

Because your laptop cannot boot into an operating system yet, you must load this driver using a secondary USB flash drive (or extract it directly onto your Windows Installation USB). Step 1: Extract the Driver Files

Disable VMD in BIOS temporarily. Reboot → Press F2 during boot → Go to Advanced → VMD Configuration → Set Enable VMD to Disabled . Save and exit. Note: After disabling VMD, Windows will use the standard NVMe driver. Performance may slightly drop, but compatibility improves.

Click . The driver will load, and your NVMe SSD should now appear in the list. Select the drive and proceed with the installation. 6. Alternative Method: Disabling VMD in BIOS

This is the most critical use case—when Windows Setup cannot see the NVMe drive.

For the Acer N20C5 (TravelMate P2 series), the storage controller is almost always Intel-based.

The Windows installation environment cannot read raw .zip files. You must extract the components first.

Ensure you downloaded the VMD driver matching your processor generation. An 11th Gen driver will often fail to initialize on a 12th Gen motherboard architecture.

Are you doing a clean installation, or is the drive not loading in Windows? Do you see "VMD" in your BIOS settings?

: Allows the Windows installer to communicate with the NVMe SSD through the Intel VMD controller.